Stabilizers

[Cub420]

Pre assembling the Cub prior to covering. Having an issue getting the stabs to fit. all trim components are new including yoke, link tube assembly & front & rear liners. with this setup I can only get one stab on the other is about a quarter of a hole off. Did some measuring & the new link tube is 5/32 larger in diameter. Removed all new stuff & replaced with used original parts both stabs will fit but it's putting a strain on the yoke. Parts book says that there is a right & left 2 hinge stab & that another part# R&L 2 hinge are the same. If I should happen to have 2 rights or 2 Lefts I could see what the problem is, But how do I know what I have & how would you tell them apart???? Any help on this would be greatly appreciated. This is not my first Cub project, but it has been very challenging one , if it's not broke or bent it's missing

 

[reileyr]

 

[bob turner]

 

[JimC]

 

[Cub420]

 

[JimC]

 

[reileyr]

 

[huston marlowe]

 

[JimC]

 

[Cub420]