hi all, have all two of my nas3 carbs apart for overhaul. turns out neither one had the recommended needle seat combination. both had a neoprene needle with a steel needle seat. (service bulletin says a no-no)
looking to trade parts or ap/ia services if you're in the western ri area for either of the following, a matched set steel needle with edged steel needle seat, or a radius lipped seat which is the one for the rubber tipped or delrin needles.
the seats are differnt part numbers, but since they aren't stamped on the parts, only way to tell for sure is by close visual under magnification and good light, (at least for my eyes)
would also consider parting out one of my carbs if you need specific nas3 parts.
or $ on the cheap if we must. thanks, tom.
looking to trade parts or ap/ia services if you're in the western ri area for either of the following, a matched set steel needle with edged steel needle seat, or a radius lipped seat which is the one for the rubber tipped or delrin needles.
the seats are differnt part numbers, but since they aren't stamped on the parts, only way to tell for sure is by close visual under magnification and good light, (at least for my eyes)
would also consider parting out one of my carbs if you need specific nas3 parts.
or $ on the cheap if we must. thanks, tom.
