- Joined
- Jul 3, 2007
- Messages
- 4,800
- Reaction score
- 1,207
This is probably a really dumb question, but I am going to ask anyway. I was going to hang my ailerons today and needed to clean out the dope (poly brush/spray/tone) from the hole in the hinges on both the wing and the aileron. I was curious if there is a easy and efficient method to effectively clean the holes out. I typically use a bolt so the threads can "cut" into the dope and pull it out a little bit at a time by going in and out many times, just a bit further each time. It is slow, but doesn't booger up the hinge. I had considered a drill bit, but decided against that.
Just curious how you guys do it.
My Cub is about 90% done. I don't figure it will take me but abuot 2 years to do the last 10%!!!!!
Too many distractions.......flying my brother's cub, flying and working on my Starduster, surfing the net looking at other airplanes, etc.
Just curious how you guys do it.
My Cub is about 90% done. I don't figure it will take me but abuot 2 years to do the last 10%!!!!!
Too many distractions.......flying my brother's cub, flying and working on my Starduster, surfing the net looking at other airplanes, etc.
