I just came out my annual yesterday.
We had the following issues.
1. total seat replacement (very much stronger) (added 1 #)
2. ELT switched and indicator added to the dash.
3. carb heat cable replaced
4. Rocker arm pins replaced with older design
5. propeller shaft seal replaced.
6. oil cooler adapter ground down so as not to rub on engine mounts
7. new tailwheel spring re-arcing for shimmy
8. new ELT battery ( inadvertently left on thus the above switch/light above)
not done yet:
1. have starter seal leaking not replaced yet
2. propeller rear bulkhead cracked etching prop, not replaced yet as CC designing front bulkhead
3. exhaust and carburetor issues not resolved with CC yet but working on a plan
Geo
We had the following issues.
1. total seat replacement (very much stronger) (added 1 #)
2. ELT switched and indicator added to the dash.
3. carb heat cable replaced
4. Rocker arm pins replaced with older design
5. propeller shaft seal replaced.
6. oil cooler adapter ground down so as not to rub on engine mounts
7. new tailwheel spring re-arcing for shimmy
8. new ELT battery ( inadvertently left on thus the above switch/light above)
not done yet:
1. have starter seal leaking not replaced yet
2. propeller rear bulkhead cracked etching prop, not replaced yet as CC designing front bulkhead
3. exhaust and carburetor issues not resolved with CC yet but working on a plan
Geo
